Advertisement
Quick Links
Commercial Salt Chlorine Generator
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions should always be followed, including the following: Failure to follow instructions can
cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property dam-
age and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Saline C 6. 0
Owner's Manual
HCSC60
Hayward Commercial Pool Products
10101 Molecular Drive, Suite 200
Rockville, MD 20850
Phone: (800) 657-2287
www.haywardcommercialpool.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
TM
Contents
Description.....................3
Installation.....................4
Operation........................7
Maintenance...................8
Parts Guide.....................9
Warranty........................11
ISHCSC60 RevE
CM
C
C
US
3101970
Conforms to UL 1081 and
CSA, C22.2 #218.1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Hayward Saline C® 6.0
Summary of Contents for Hayward Saline C® 6.0
-
Page 1: Table Of Contents
The NOTICE label indicates special instructions that are important but not related to hazards. Hayward Commercial Pool Products 10101 Molecular Drive, Suite 200 Rockville, MD 20850 Phone: (800) 657-2287 www.haywardcommercialpool.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 2 Do not close filter manual air relief valve until a steady stream of water (not air or air and water) is discharged. Notice: This product should be installed and serviced only by a qualified pool professional. SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
-
Page 3: Description
Saline C 6.0 HCSC60 60Hz Sizing Guidelines Chlorinator sizing must comply with local codes. Please contact your local health department for specific requirements or contact your local Hayward representative for assistance. Head Loss Data (ft of H USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 4: Installation
This outlet must be interlocked with the circulation pump Blue Control of the pool so that if the pump is turned off, power to the Saline C 6.0 is disconnected and the system is unable to operate. Cord USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 5 In either case the cell housing must be installed as the last component in the return to the pool, after all other equipment. The vessel has 4 mounting holes for attaching to a floor or mounting surface. See the plumbing diagrams below. SALINE C 6.0 System Plumbing Bypass Manifold Plumbing USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 6 (refer to arrow on the T-fitting). Plug the flow switch into the power “U” Switch supply at the connector shown above. Outlet Connector Electrolytic Cell Wiring Connect the cell to the power supply with the connector provided. Cell “Z” Connection Outlet USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
-
Page 7: Operation
® for the Hayward system to operate, salt must be added directly to the pool at least 24 hours before the system is started. 28 pounds of salt must be added for every 1000 gallons of pool water to reach 3500 ppm and 40 pounds of salt must be added for every 1,000 gallons of pool water to reach 5000 ppm. -
Page 8: Maintenance
Once finished, insert the electrode stack assembly into the vessel and reconnect the blue connector to the power supply. • Turn the handles of the vessel clockwise until tight, and then push down on the blue glamour cap to avoid water from entering the top of the cell. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... -
Page 9: Parts Guide
Once all water is drained, replace the drain plug, replace the electrode stack and close the vessel lid. Make sure no water is in the vessel if there is a possibility of freezing. Parts Guide USE ONLY HAYWARD GENUINE REPLACEMENT PARTS... - Page 10 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 11 The Hayward Pool products warranty does not apply to components manufactured by others. For such products, the warranty established by the respective manufacturer will apply. The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its pool products and is in lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose.
-
Page 12: Warranty
Hayward is a registered trademark and Saline C is a trademark of Hayward Industries, Inc. © 2013 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.
Need help?
Do you have a question about the Saline C® 6.0 and is the answer not in the manual?
Questions and answers