Kyocera TASKalfa 3051ci Technical Reference Manual page 104

Chapter 6 Permanent Parameters
6-4
Table 6.1. Interface-dependent Parameters (Sheet 3 of 3)
Environment Parameter
a
Character spacing U2
a
Character spacing U3
Country code U6
Code set at power up in U7
daisywheel emulation
Font pitch for fixed- U8
pitch scalable fonts
U9
Font height for the V0
a
default scalable font
V1
V2
a, e
Default scalable font V3
a
Ignored in some emulation modes.
b
For models supporting A3 and ledger size paper.
c
Characters higher than 127 are printed regardless of the C8 value. However, setting C8 to 0 does
not print character code 160.
d
P4/P5—Automatic Emulation Switching
The FRPO P4 command establishes Automatic Emulation Switching (AES) between KPDL and
the alternative emulation. With the P4 value of 1, the printing system will switch from KPDL
emulation to non-KPDL emulation, or vice versa. Switching is triggered by the command
specified by the FRPO P7 value.
The FRPO P5 value specifies the alternative emulation to which the printing system switches
from KPDL. The factory default for P5 is the HP LaserJet.
The automatic emulation switching mode may not operate properly if the print job contains
PRESCRIBE commands.
Value
Characters per inch (integer value)
Characters per inch (fraction value)
0: US-ASCII
1: France
2: Germany
3: UK
4: Denmark
5: Sweden
6: Italy
7: Spain
8: Japan
9: US Legal
10: IBM PC-850 (Multilingual)
11: IBM PC-860 (Portuguese)
12: IBM PC-863 (Canadian French)
13: IBM PC-865 (Norwegian)
14: Norway
15: Denmark 2
16: Spain 2
17: Latin America
50 – 99:HP PCL symbol set coding (See page 7-
37.)
0: Same as the default emulation mode (P1)
1: IBM
2: Daisywheel
3: HP Roman8 (US ASCII)
4: Same as 3
5: Epson LQ-850
6: HP Roman-8
7 – 99:HP PCL symbol set coding (See page 7-
37.)
Integer value in cpi: 0 – 99
Fraction value in 1/100 cpi: 0 – 99
Integer value in 100 points: 0–9
Integer value in points: 0–99
Fraction value in 1/100 points: 0, 25, 50, or 75
Name of typeface of up to 32 characters, enclosed
with single or double quotation marks
Factory setting
10
0
0
0
10
0
0
12
0
—