Table of Contents
Advertisement
Replacing the Display Assembly
1. Follow the instructions in
Before You
2. Place the display assembly in position and replace the screw near the left hinge that secures the display assembly to the computer base.
3. Place the display grounding cable over the screw hole and replace the display cable grounding screw.
4. Connect the display cable to the connector on the system board.
5. Route the Mini-Card antenna cables through the routing guides on the computer base.
6. Connect the Mini-Card antenna cables to the Mini-Card (see
7. Close the display and replace the screw that secures the display assembly to the computer base.
8. Replace the middle cover (see
9. Replace the memory module (see
10. Replace the palm rest assembly (see
11. Replace the hard-drive assembly (follow the instructions from
12. Replace the keyboard (see
13. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel
Removing the Display Bezel
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1. Follow the instructions in
Before You
2. Remove the display assembly (see
3. Remove the two rubber pads that cover the display bezel screws.
4. Remove the two screws that secure the display bezel to the display assembly.
Begin.
Replacing the
Replacing the Middle
Cover).
Replacing the Memory
Module).
Replacing the Palm Rest
Replacing the
Keyboard).
Battery).
Begin.
Removing the Display
Assembly).
Mini-Card).
Assembly).
step 5
to
step 7
in
Replacing the Hard
Drive).
Advertisement
Table of Contents
