Table of Contents
Advertisement
2. Place the status lights board on the computer base.
3. Replace the screw that secures the status lights board to the computer base.
4. Slide the status lights board cable into the system board connector and press the connector-tab down to secure the cable.
5. Replace the memory module (see
6. Replace the palm rest assembly (see
7. Replace the hard-drive assembly (follow the instructions from
8. Replace the keyboard (see
9. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Replacing the Memory
Module).
Replacing the Palm Rest
Replacing the
Keyboard).
Battery).
Assembly).
step 5
to
step 7
in
Replacing the Hard
Drive).
Advertisement
Table of Contents
