Awms Snmp - Dell PowerConnect W-Airwave Manual

(Controller-Name) (config) # mobility-manager <AMP IP> user <MMS-USER> <MMS-SNMP-
PASSWORD> trap-version 2c
NOTE: This command creates an SNMPv3 user on the controller with authentication protocol configured to 'sha' and privacy
protocol 'DES'. The user and password must be at least eight characters, because the Net-SNMP package in AWMS adheres to
this IETF recommendation. ArubaOS automatically creates Auth and Privacy passwords from this single password. If mobility-
manager is already using a preconfigured SNMPv3 user ensure the Privacy & Authentication passwords are the same.
NOTE: This command also creates the AWMS server as an SNMPv3 Trap Host in the controller's running configuration.
Sample: mobility-manager 10.2.32.1 user airwave123 airwave123
(Controller-Name) (config) # write mem

AWMS SNMP

Login into the AMWS server with proper administrative access and issue the following command for all
controllers (master and locals):
NOTE: Do not use these commands if using AWMS GUI.
[root@AWMS ~]# snmpwalk -v3 -a SHA -l AuthPriv -u <MMS-USER> -A <MMS-SNMP-PASSWORD> -X
<MMS-SNMP-PASSWORD> <ARUBA CONTROLLER IP ADDRESS> wlsxSystemExtGroup
WLSX-SYSTEMEXT-MIB::wlsxSysExtSwitchIp.0 = IpAddress: 10.51.5.222
WLSX-SYSTEMEXT-MIB::wlsxSysExtHostname.0 = STRING: aruba-3600-2
.
..
WLSX-SYSTEMEXT-MIB::wlsxSysExtSwitchLastReload.0 = STRING: User reboot.
WLSX-SYSTEMEXT-MIB::wlsxSysExtLastStatsReset.0 = Timeticks: (0) 0:00:00.00 response
[root@AWMS ~]#
NOTE: Unless this SNMP walk command is issued properly on all of the controllers, they will not properly populate client and
rogue statistics. Ensure the user and passwords match exactly to those entered in above sections.
Sample: snmpwalk -v3 -a SHA -l AuthPriv -u airwave123 -A airwave123 -X airwave123
10.51.3.222 wlsxSystemExtGroup
If you do not use AWMS GUI to offload WMS, you must add a cronjob on the AWMS server to ensure
continued statistical population. Because the MIB walk/touch does not persist through a controller reboot, a
cronjob is required to continually walk and touch the MIB.
36 | Dell PowerConnect ArubaOS & AWMS Commands Dell PowerConnect W AirWave 7.2 | Best Practices Guide