Controller Setup (Master & Local) - Dell PowerConnect W-Airwave Manual

Figure 5 AMON Data Collection setting in AMP Setup > General
3. Select Save.
Controller Setup (Master & Local)
CAUTION: Enabling these commands on Dell PowerConnect ArubaOS versions prior to 6.0.1 can result in performance issues on
the controller. If you are running previous firmware versions such as Dell PowerConnect ArubaOS 6.0.0.0, you should upgrade to
Dell PowerConnect ArubaOS 6.0.1 (to obtain RF utilization metrics) or 6.1 (to obtain RF utilization and classified interferer
information) before you enter this command.
SSH into the controller, enter "enable" mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP IP>
(Controller-Name) (config) # write mem
12 | Configuring AWMS for Global Dell PowerConnect W Infrastructure Dell PowerConnect W AirWave 7.2 | Best Practices Guide