Print Test - Oki LE840DT User Manual

2. PRINTER SETUP
2.8

Print Test

After your operating environment has been set, perform a print test.
1. Perform a print test by using the Printer Driver or an Issue Command.
The printer driver's Properties screen allows you to set the
communication conditions, media size, and other printing conditions
in accordance with your operating environment. For details, refer to
the Help for the Windows Printer Drivers screen.
Example: Stock tab display of the Printer Driver's Properties Screen
Print Method
Sensor
Label Gap
Mode
Issue
Post-print Action
(Cut)
Print Speed
Fine Adjustment
Print Method:
Sensor:
Issue Mode:
Post-print Action: Whether to use the cutter or not is selectable.
Fine Adjustment:
2. Confirm the print test result.
When a print start position, cut/strip position, or print tone needs to
•
be adjusted: ⇒ Section 2.9 Position and Print Tone Fine
Adjustment
When pre-printed media is used, and if a print start position is not
•
properly detected: ⇒ Section 2.10 Threshold Setting
E2-49
OKI LE840 Printing Preferences
Direct thermal or thermal transfer is selectable.
Media sensor type is selectable.
Batch, strip or cut is selectable.
Adjustment values for the feed amount, cut/strip
position, etc. can be set.
2.8 Print Test