Dump Mode Setting - Oki LE840DT User Manual

2. PRINTER SETUP

2.6.7 Dump Mode Setting

USER SYSTEM MODE
<5>BASIC
<6>Z-MODE
<7>AUTO CALIB
<8>DUMP MODE
NOTES:
1. If a file with the same name
already exists in the USB
memory, it will be
overwritten.
2. Selecting "RS-232C" or
"CENTRONICS" without the
optional board installed
causes a 0-KB file to be
output.
3. If an error occurs while using
the USB memory, the error
message is displayed. For
details, refer to Section 2.6.12
Copying Data to/from USB
Memory.
In Dump Mode, the data in the receive buffer is printed. The data is
expressed in hexadecimal values. This operation allows verification of
the programming commands or the debug of the program.
(1) BUFFER
Select the receive buffer to dump.
 RS-232C
 CENTRONICS
 LAN
 BASIC1
 BASIC2
 USB
 RFID
(2) DUMP LIST
This parameter is to choose the output destination.
 USB MEMORY
 PRINT
 When USB MEMORY is selected:
A file is automatically created in the USB memory and named in the
following format based on the printer model and saved date.
/ATA0/DUMP/LE840_DUMP_1209271030.DAT / (e.g.
LE840(203dpi model), 10:30, Sep 27, 2012)
 When PRINT is selected:
Choose a printing method.
 ON DEMAND
 ALL
E2-27
RS-232C receive buffer
Centronics receive buffer
Network I/F receive buffer
BASIC Interpreter:
I/F → Interpreter buffer
BASIC Interpreter:
Interpreter buffer → I/F
USB receive buffer
RFID receive buffer
Saves in the USB memory. → 
Prints out → 
Prints 166 lines of data (approx. 50 cm), then
stops. Subsequent data is printed when the
[ENTER] key is pressed.
Prints all data in the receive buffer.
2.6 Printer Setting