Page 3
LE810DT Top Access Door Media Supply Operator Panel Guide Print Head Print Head Latch Latch Media Holder Media Hold- Down Print Head Print Assembly Backing Retainer Prongs Platen Roller Dispenser Latch Outside Sensor Media Adjust Backing Take-Up Guide Knob Spindle...
Page 4
1. Open the Top Access Door by swinging it up. 5. Load the roll onto the Media Holder so that the printing side of the media faces upwards as it unwinds from the roll. Push the roll all the way to the inside of the printer, then push the Media Supply Guide back in until it fits snugly against the outside of the media roll.
Page 5
8. Raise the Outside Media Guide to the closed position and 13. Manually turn the Backing Take-Up Spindle counter- push the guide inward until it barely contacts the outside clockwise to take up all the slack in the backing. edge of the media. Note: Inspect the media routing and verify 9.
LE810DT Install the Driver 1. Insert the Printer Software CD in the CD-ROM drive. The CD will autorun. 4. Select Install Driver under Driver Setup. 2. Select your language. 3. If you accept the license agreement, select I Accept. 5. When the Add Printer wizard appears, select Next.
Page 7
STATMON.EXE in the folder C:\Program Files\Oki\StatMon\ 7. Select the port that your LE810DT is connected to from the list of Available Ports. If you want this printer to be your default printer, then check the box next to “I want to use this printer as the Windows default printer”.
Need help?
Do you have a question about the LE810DT and is the answer not in the manual?
Questions and answers