Table of Contents
Advertisement
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs
and to view the current security configuration. (See
Navigating Through The Setup Utility on page 2 for more
information.)
The following tables show the names of the menu fields
for the Security menu and submenus, all of the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use. The default condition
is no passwords required and no write protection
If you set a password, write it down and
keep it in a safe place. If you forget the
password you will have to contact your
support representative (1-800-8FHJITSU)
to regain access to your secured functions
and data.
Information
Supervisor Password
User Password
Set Supervisor Password
Set User Password
Set User Password Length:
Password on Boot:
On Automatic Wake up:
KB Lock on Resume:
Boot from Removable Media:
Flash Write:
Hard Disk Security
Owner Information
.
InsydeH20 Setup Utility
Main
Advanced
Security
: Clear
: Clear
<Enter>
<Enter>
<Disabled>
<Disabled>
<Disabled>
<Enabled>
Figure 10. Security Menu
S e c u r i t y M e n u
If you make an error when re-entering
■
the password a [Warning] will be dis-
played on the screen. To try again press
the Enter key and then retype the pass-
word. Press the Esc key to abort the
password setting process.
Entering a password incorrectly 3 times
■
in a row will cause the keyboard and
mouse to be locked out and the warning
[System Disabled] to be displayed.
If this happens restart the computer by
turning off and on the power with the
power switch and use the correct pass-
word on reboot.
■
If the Power Management Security is
Enabled and the Password on Boot is
Disabled you will not have to type your
password upon resuming the system
from the Suspend or Save-to-Disk
modes. Power Management Security
will work only if Password boot is
enabled.
Boot
Exit
Press <Enter> key to set
Supervisor Password to
enable any password
features.
Then password entry is
<0>
required to enter BIOS
Setup.
<All>
Up/Dn Select Boot Device
<>
Select Screen
Select Item
Enter Select
F1 = Help
F9 = Setup Defaults
F10 = Save and Exit
Esc = Exit
Submenu
15
Advertisement
Table of Contents
