Security Menu - Setting The Security Features - Fujitsu LIFEBOOK P701 Bios Manual

L I F E B O O K P 7 0 1 B I O S
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security features of your notebook to fit operating needs and to view
the current data security configuration. (See Navigating through the Setup Utility on page 2 for more information.)
The following tables show the names of the menu fields for the Security Menu and its submenus, all the options for
each field, the default settings and a description of the field's function and any special information needed to help
understand the field's use. The default condition is no passwords required and no write protection.
Remember your passwords! If you set and forget your User and Master hard disk passwords, Fujitsu

America will not be able to reset it. You may lose data and have to replace your system board or hard disk
drive.
WARNING. VERY IMPORTANT if your hard disk drive is protected using a Full Disk Encryption (FDE)

"engine". FDE encrypts all data as it is written to the hard drive. When data is retrieved from the hard
drive, it is decrypted by the same engine.
FDE, all data and applications on the hard drive will remain encrypted and will effectively be lost.
sure to remember your hard disk password.
Entering a password incorrectly 3 times in a row causes the keyboard and mouse to be locked out and

[System Disabled] to be displayed. If this occurs, restart the computer by turning off and on the power
with the power switch and use the correct password on reboot.
If you make an error when re-entering the password a Warning will be displayed. To try again press

[Enter], then retype the password, or press [Esc] to abort the password process.
If the Security Panel on Resume is Enabled and the Password on Boot is Disabled you will not have to

type your password upon resuming the system from the Suspend or Save-to-Disk modes. Power Man-
agement Security will work only if Password boot is enabled.
Info
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Minimum User Password Length:
Password on Boot:
On Automatic Wake up:
Boot from Removable Media:
Flash Write:
Boot Menu:

Hard Disk Security

Owner Information

TPM (Security Chip) Setting
F1 Help
ESC Exit
20
Phoenix SecureCore(tm) Tiano Setup
System Advanced Security
Clear
Clear
[Enter]
[Enter]
[0]
[Disabled]
[Disabled]
[All]
[Enabled]
[Enabled]
Select Item
Select Menu
Figure 14. Security Menu
If you forget your hard disk security password on a system with
Boot Exit
Change Values
-/Space
Select Sub-Menu
Enter

Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
F9 Setup Defaults
F10 Save and Exit
Be