Security Menu - Setting The Security Features - Fujitsu AH530 Manual

SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs
and to view the current data security configuration. (See
Navigating through the Setup Utility on page 2 for more
information.)
The following tables show the names of the menu fields
for the Security Menu and its submenus, all the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use. The default condition
is no passwords required and no write protection.
Remember your passwords! If you set
and forget your User and Master hard
disk passwords, Fujitsu Computer
Systems will not be able to reset it. You
may lose data and have to replace your
system board or hard disk drive.
F1
ESC
Phoenix SecureCore(tm) Setup Utility
Info System Advanced
Supervisor Password Is:
User Password Is:
Drive0 HDD Password Is:
Set Supervisor Password
Set User Password
Set Drive0 HDD Password:
BIOS Password on Boot:
HDD Password on Boot:
Help Select Item
Exit Select Menu
Figure 6. Security Menu



Security Boot
Clear
Clear
Clear
[Enter]
[Enter]
[Enter]
[Disabled]
[Enabled]
-/Space Change Values
Enter Select Sub-Menu
S e c u r i t y M e n u
Entering a password incorrectly 3 times in a
row causes the keyboard and mouse to be
locked out and the warning [System Dis-
abled] to be displayed. If this happens,
restart the computer by turning off and on the
power with the power switch and use the cor-
rect password on reboot.
If you make an error when re-entering the
password a Warning will display on the
screen. To try again press [Enter], then retype
the password. Press [Esc] to abort the pass-
word setting process.
If Security Panel on Resume is Enabled and
the Password on Boot is Disabled you will not
have to type your password upon resuming
the system from the Suspend or Save-to-
Disk modes. Power Management Security
will work only if Password boot is enabled.
Exit
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
F9 Setup Defaults
F10 Save and Exit
11