Security Menu - Setting The Security Features - Fujitsu LIFEBOOK AH532 Manual

S T Y L I S T I C L H 5 3 2 / A H 5 3 2 B I O S
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data secu-
rity features of your notebook to fit your operating
needs and to view the current data security configura-
tion. (See Navigating through the Setup Utility on page
2 for more information.)
The following tables show the names of the menu
fields for the Security Menu and its submenus, all the
options for each field, the default settings and a
description of the field's function and any special
information needed to help understand the field's use.
The default condition is no passwords required and no
write protection.
Remember your passwords! If you set and
forget your User and Master hard disk
passwords, Fujitsu America will not be able
to reset it. You may lose data and have to
replace your system board or hard disk drive.
Info System
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Password on Boot:
Hard Disk Security
TPM (Security Chip) Setting
F1 Help
ESC Exit
10
Phoenix SecureCore Tiano Setup
Advanced
Clear
Clear
[Enter]
[Enter]
[Disabled]
Select Item -/Space
Select Menu Enter
Figure 6. Security Menu
Entering a password incorrectly 3 times in

a row causes the keyboard and mouse to
be locked out and the warning [System
Disabled] to be displayed. If this happens,
restart the computer by turning off and
on the power with the power switch and
use the correct password on reboot.
If you make an error when re-entering the

password a Warning will display on the
screen. To try again press [Enter], then
retype the password. Press [Esc] to abort
the password setting process.
If Security Panel on Resume is Enabled

and the Password on Boot is Disabled you
will not have to type your password upon
resuming the system from the Suspend or
Save-to-Disk modes. Power Management
Security will work only if Password boot is
enabled.
Security Boot
Change Values
Select Sub-Menu
Exit
Item Specific Help
Press <Enter> key to
set Supervisor
Password to enable
any password features.
Then password entry
is required to enter
BIOS Setup.
F9 Setup Defaults
F10 Save and Exit