Pc Cards/Expresscards; Installing Pc Cards; Removing Pc Cards - Fujitsu LifeBook N6460 User Manual

PC Cards/ExpressCards™

Your LifeBook notebook supports Type I and Type II PC
TM
Cards and ExpressCards
With these cards you can perform a variety of functions
depending on which type of card you install. You can
install one or two cards at a time, depending on its type.
PC Cards should be installed in the bottom slot and
ExpressCards in the top slot. (Figure 4-8)
Some available PC/ExpressCards:
Wireless LAN PC Cards (Type II)
■
ExpressCard Hybrid TV Tuner
■
Local area network (LAN) cards (Type II)
■
IDE solid-state disk cards (Type II)
■
SCSI cards (Type II)
■
PC Cards that conform to PCMCIA 2.1 or CardBus
■
For further information, refer to the instructions
supplied with your card(s).

INSTALLING PC CARDS

PC Cards are installed in the PC Card slot (Figure 4-8).
To install a PC Card, follow these steps:
You may be required to log on as an
Administrator or member of the
Administrator's Group to complete this
procedure. If the computer is connected to
a network, network policy settings may
also prevent you from completing this
procedure.
Installing or removing a PC Card during
■
your LifeBook notebook's shutdown or
bootup process may damage the card
and/or your LifeBook notebook.
Do not insert a PC Card into a slot if
■
there is water or any other substance on
the card as you may permanently
damage the card, the notebook, or both.
1
2
Figure 4-8. Installing/Removing PC Cards
, in separate dedicated slots.
U s e r - I n s t a l l a b l e F e a t u r e s
3
1 PC Card Eject Button
2 PC Card Slot (bottom slot)
3 PC Card
1. See your PC Card manual for instructions on the
installation of your card. Some cards may require
that your notebook is off while installing them.
2. Make sure there is no PC Card currently in the slot.
If there is, see Removing PC Cards.
3. If the eject button is extended, press it until it clicks.
4. Insert the card into the slot with the label facing up.
5. Push the card firmly into the slot until it is seated in
the connector.

REMOVING PC CARDS

See your PC Card manual for specific instructions on
removing your card. Some cards may require your note-
book to be in Sleep Mode or Off during removal.
Windows has a shutdown procedure for
■
PC Cards that must be followed before
removing a card. (Review your operating
system manual for the correct proce-
dure.) It is good practice to remove
devices using the Safely Remove Hard-
ware icon in the system tray.
■ If the dialog box states that the device
cannot be removed, you must save all of
your open files, close any open applica-
tions and shut down your notebook.
2. Unlock the card from the slot by pressing the eject
button. When pressed, the button will pop out.
3. Firmly press the button again until it is flush with
the notebook. This will eject the card slightly out of
the slot allowing you to remove the card.
If the PC Card has an external connector
and cable, do not pull the cable when
removing the card.
43