Power Button Board; Removing The Power Button Board - Dell Alienware M17X R3 Service Manual

Power Button Board

WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery Pack" on page 13) before working inside the computer.

Removing the Power Button Board

1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery pack (see "Removing the Battery Pack" on page 13).
3 Remove the compartment door (see "Removing the Compartment Door"
on page 15).
4 Remove the center control cover (see "Removing the Center Control
Cover" on page 49).
5 Remove the keyboard (see "Removing the Keyboard" on page 55).
6 Disconnect the power button board cable from the connector on the
system board.
7 Remove the two screws that secure the power button board to the palm
rest assembly.
8 Lift the power button board off the palm rest assembly.
16
Power Button Board
67