Graphics-Card Heat Sink Fan; Removing The Graphics-Card Heat Sink Fan - Dell Alienware M17X R3 Service Manual

Graphics-Card Heat Sink Fan

WARNING:
shipped with your computer. For additional safety best practices information, see
the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
operation. Ensure that it has had sufficient time to cool before you touch it.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery Pack" on page 13) before working inside the computer.

Removing the Graphics-Card Heat Sink Fan

1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery pack (see "Removing the Battery Pack" on page 13).
3 Remove the compartment door (see "Removing the Compartment Door"
on page 15).
4 Disconnect the graphics-card heat sink fan cable from the connector on
the system board.
5 Loosen the three captive screws that secure the graphics-card heat sink fan
to the chassis.
6 Lift the graphics-card heat sink fan along with the cable away from the
chassis.
Before working inside your computer, read the safety information that
The graphics-card assembly may be very hot during normal
Graphics-Card Heat Sink Fan
7
31