Installing Or Replacing The Microprocessor - Lenovo ThinkServer RD430 Hardware Maintenance Manual

10. Install the four screws to secure the new heat sink on the system board. It is recommended that you
carefully install the four screws using the following method to avoid any possible damage to the system
board.
a. Partially tighten screw
it. Do not over-tighten the screws.
b. Partially tighten screw
it. Do not over-tighten the screws.
Figure 88. Installing the screws to secure the heat sink
11. If you are instructed to return the old heat sink, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 182.

Installing or replacing the microprocessor

This topic provides instructions on how to install or replace the microprocessor.
Installing the second microprocessor
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 81.
This topic provides instructions on how to install the second microprocessor.
1
, then firmly tighten screw
2 , then firmly tighten screw
3
, and then return to screw
4 , and then return to screw
.
Chapter 6 Installing, removing, or replacing hardware
1
and firmly tighten
2 and firmly tighten
135