Lenovo ThinkServer RD430 Hardware Maintenance Manual page 59

Use the following instructions to connect cables from the RAID card to the expander card first:
• If you are using a ThinkServer RAID 500 Adapter, do the following:
1. Use a mini-SAS to mini-SAS signal cable and connect the mini-SAS connector on one end of the
cable to the port 0 on the ThinkServer RAID 500 Adapter. Then, connect the mini-SAS connector on
the other end of the cable to the connector 1 on the expander card.
2. Use another mini-SAS to mini-SAS signal cable and connect the mini-SAS connector on one end of
the cable to the port 1 on the ThinkServer RAID 500 Adapter. Then, connect the mini-SAS connector
on the other end of the cable to the connector 2 on the expander card.
• If you are using a ThinkServer RAID 700 Adapter, do the following:
1. Use a mini-SAS to mini-SAS signal cable and connect the mini-SAS connector on one end of the
cable to the ports 3-0 on the ThinkServer RAID 700 Adapter. Then, connect the mini-SAS connector
on the other end of the cable to the connector 1 on the expander card.
2. Use another mini-SAS to mini-SAS signal cable and connect the mini-SAS connector on one end
of the cable to the ports 7-4 on the ThinkServer RAID 700 Adapter. Then, connect the mini-SAS
connector on the other end of the cable to the connector 2 on the expander card.
Refer to the following topics for information about the connector locations on the RAID card and expander
card:
• "RAID card" on page 37
• "Expander card" on page 38
.
Chapter 3 Product overview
45