Fujitsu MPF3XXXAT Product Manual page 99

Table 5.5 Information to be read by IDENTIFY DEVICE command (5 of 5)
*20 Word 93: CBLID– detection results
Hardware reset result. The contents of bits 12-0 of this word shall change only during the
execution of a hardware reset.
Bit 15:
Bit 14:
Bit 13:
Bit 12-8:
Bit 12:
Bit 11:
Bit 10-9: These bits indicate how Device 1 determined the device number:
Bit 8:
Bit 7-0:
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2-1:
Bit 0:
*21 Word 128: Security status
Bit 15-9:
Bit 8:
Bit 7-6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
5 - 34
Shall be cleared to zero
Shall be set to one
1=Device detected CBLID– above V
0=Device detected CBLID– below V
Device 1 hardware reset result. Device 0 shall clear these bits to zero
Device 1 shall set these bits as follows:
Reserved
0=Device 1 did not assert PDIAG–
1=Device 1 asserted PDIAG–
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is unknown
Shall be set to one
Device 0 hardware reset result. Device 1 shall clear these bits to zero
Device 0 shall set these bits as follows:
Reserved
0=Device 0 does not respond when Device 1 is selected
1=Device 0 responds when Device 1 is selected.
0=Device 0 did not detect the assertion of DASP–
1=Device 0 detected the assertion of DASP–
0=Device 0 did not detect the assertion of PDIAG–
1=Device 0 detected the assertion of PDIAG–
0=Device 0 failed diagnostics
1=Device 0 passed diagnostics
These bits indicate how Device 0 determined the device number:
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is unknown
Shall be set to one
Reserved
Security level 0=High, 1=Maximum
Reserved
1=Enhanced security erase supported
1=Security count expired
1=Security frozen
1=Security locked
1=Security enabled
1=Security supported
C141-E099-01EN
IH
IL