Buttons - Dell 1130 Laser Mono Printer Troubleshooting Manual

LED Status
Orange On
Jam ( )
Online/Error Off
( )
Green On
Blinking
Red On
Blinking
[a]
Estimated cartridge life means the expected or estimated toner cartridge life, which indicates the average capacity
of print-outs and is designed pursuant to ISO/IEC 19752. The number of pages may be affected by operating
environment, printing interval, media type, and media size. Some amount of toner may remain in the cartridge even
when red LED turned on and the printer stops printing.
Dell does not recommend using non-genuine Dell toner cartridge such as refilled or re-manufactured. Dell cannot
guarantee non-genuine Dell toner cartridge's quality. Service or repair required as a result of using non-genuine
Dell toner cartridges will not be covered under the machine warranty.
All printing errors will be appear in the Printer Status Monitor program window. If the problem persists, call for
service.

Buttons

(Cancel button)
By pressing the (cancel button), you can:
Function
Printing In Ready mode, press and hold this button for about 2 seconds until the status LED blinks slowly, and
demo release. (See
[a]
page
Printing In Ready mode, press and hold this button for about 5 seconds until the status LED blinks fast, and
configuration release. (See
[b]
sheet
Printing a In Ready mode, press and hold this button for about 10 seconds until the status LED blinks slowly, and
cleaning release. (See
[b]
sheet
Cancel print Press
job
machine and the computer and then the machine returns to ready mode. This may take some time
depending on the size of the print job.
Manual print Press
manual tray when you select Manual Feeder for Source from your software application.
[a]
When you print the demo page for Dell 1130, configuration sheet is printed as well.
[b]
Dell 1130n only
A paper jam has occurred. (See
The machine is off-line.
The machine is in power saver mode.
The machine is on-line and can receive data from the computer.
When the LED blinks slowly, the machine is receiving data from the computer.
When the LED blinks rapidly , the machine is printing data.
The cover is open. Close the cover.
There is no paper in the tray. Load paper in the tray.
The machine has stopped due to a major error.
Your system has some problems. If this problem occurs, contact your service
representative.
The toner cartridge has almost reached its estimated cartridge life
recommended to replace the toner cartridge. (See
A minor error has occurred and the machine is waiting for the error to be cleared.
When the problem is cleared, the machine resumes.
Toner is low. Replace the cartridge. The estimated cartridge life
Prepare a new cartridge for replacement. You may temporarily increase the printing
quality by redistributing the toner. (See
Printing a demo page.)
Printing a machine report.)
Cleaning the inside.)
(cancel button) during printing. The red LED blinks while the print job is cleared from both the
(cancel button) each time you load a sheet of paper in the
Description
Clearing paper jams.)
Redistributing
Description
[a]
. It is
Replacing the toner cartridge.)
[a]
of toner is close.
toner.)