D-Link DXS-3600-EM-4QXS Hardware Installation Manual page 24

Set the terminal emulation software as follows:
• Select the appropriate serial port (COM1 or COM2).
• Set the data rate to 115200 baud.
• Set the data format to 8 data bits, 1 stop bit, and no
parity.
• Set flow control to none.
• Under Properties, select VT100 for Emulation mode.
• Select Terminal keys for Function, Arrow and Ctrl keys.
Make sure to use Terminal keys (not Windows keys)
are selected.
NOTE: When using HyperTerminal with the Microsoft® Windows® 2000 operating system, ensure
that Windows 2000 Service Pack 2 or later is installed. Windows 2000 Service Pack 2 allows use of
arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for information on Win-
dows 2000 service packs.
After correctly configuring the terminal, plug the power cable into the power receptacle on the back of the switch. The
boot sequence will appear in the terminal.
DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
Figure 4-1 COM1 Properties - Port Settings
Figure 4-2 COM1 Properties - General Settings
17