Removing An I/O Module; Installing An I/O Module - Dell External M1000e t Owner's Manual

Removing An I/O Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. If you have not already installed the cable enumerators to make removal and replacement of the I/O modules easier
and faster, install them now.
For more information, see the
2. Disconnect the cables attached to the I/O module.
3. Lift the latch on the end of the module's handle and rotate the handle away from the module.
4. Slide the I/O module out of the enclosure.
5. Install the I/O connector cover.
Figure 47. Removing and Installing an I/O Module
1. I/O connector cover
2. I/O module
3. release latch
4. handle

Installing An I/O Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
Rack Installation Guide at support.dell.com/manuals.
85