P-B 2.5 Mm Allen Wrench - RocketFish RF-TVMP20 Manual

RF-TVMP20 TV Wall Mount
STEP 8 - Adjusting the vertical position, the tilt, and the horizontal position
Important! You will need to adjust this product after installation is complete.
Make sure all your equipment is properly installed on the product before adjusting. This product should move
smoothly and easily through the full range of motion and stay where you set it. If movements are too easy or diffcult or
if product does not stay in desired position, follow the adjustment instructions to create smooth and easy movements.
NOTE: Depending on your product and the type of adjustment, it may take many turns to notice a difference.
Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load,
you should repeat these adjustment steps to ensure safe and optimum operation.
1 To increase or decrease the lift tension setting, use the 4mm Allen wrench (P-A).
2 To increase or decrease the tilt tension setting, use the 4mm Allen wrench (P-A).
3 Using the 2.5mm Allen wrench (P-B) adjust the tension of the horizontal movement. If this product moves
too easily from side-to-side, increase the tension (+). If the product is too difficult to move from side-to-side,
decrease the tension (-).
Adjusting the factory-set tension
Increase
If TV weight
exceeds product's
factory setting, it
won't stay up
when raised. To
prevent TV from
sagging
downward,
increase tension
setting.
Decrease
If TV weight is
2
lower than
product's factory
setting, it won't
stay down when
lowered. To
prevent TV from
drifting upward,
decrease tension
setting.
For customer service, call: 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010
(Mexico)
Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
1
You'll need
P-A 4 mm Allen wrench
P-A
3

P-B 2.5 mm Allen wrench

15