RocketFish RF-TVMP20 Manual page 11

Tv wall mount

Hide thumbs Also See for RF-TVMP20:

RF-TVMP20 TV Wall Mount

STEP 5 - Option 1: Installing on a wood stud wall

Note: Any wallboard or material covering the wall must not exceed 5/8" (16 mm).

Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.

Align the wall plate (A) at the height you determined in the previous step and make sure that it is level. Use a

pencil to mark the lag bolt hole locations (2) on the stud centers. Remove the wall plate.

Drill pilot holes to a depth of 2-3/4 in. (70 mm) using a 7/32 in. (5.5 mm) diameter drill bit.

Align the wall plate (A) with the pilot holes, insert the lag bolts (W-A) through the holes in the wall plate,

then tighten the lag bolts only until they are firm against the wall plate.

CAUTION: Avoid potential injuries or property damage!

DO NOT over-tighten the lag bolts (W-A).

You'll need

W-A (2)

Level

Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)

W-A

Edge-to edge

A Wall

stud finder

plate

Center pencil mark made in

Step 1.

2-3/4 in.

(70 mm)

Pencil

1/2" socket

wrench

Drill

7/32" wood

drill bit

Table of Contents