Removing The Front I/O Panel; Replacing The Power Supply; Removing The Power Supply - Dell XPS 8200 Technical Specifications

User manual
Table of Contents

Advertisement

Removing the Front I/O Panel

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the power cable from your computer, and then press the power button to ground the system board.
4.
 Open the computer
cover.
5.  Disconnect the control panel cable from the control panel connector. Disconnect the I/O cable from the connector on the system board.
Note the routing of the control panel cable as you remove it from the computer so that you can replace it correctly.
 
6.  Remove all cables that are connected to the front I/O panel.
7.  From inside the computer cover, remove the mounting screw that secures the front I/O panel to the computer.
8.  Remove the front I/O panel from the computer.
9.  Reinstall the front I/O panel by reversing steps 5 through 7.
10.
 Close the computer
cover.
11.  Connect your computer and devices to their electrical outlets, and turn them on.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

Replacing the Power Supply

Removing the Power Supply

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the power cable from your computer, and then press the power button to ground the system board.
4.
 Open the computer
cover.
5.  Be sure the AC power cable is disconnected from the back of the power supply. Then disconnect the DC power cables from the system board and the
drives.
 
"Safety
Instructions."
"Safety
Instructions."

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dimension 8200

Table of Contents