Getting Started; Battery Installation - VTech MobiGo 2 Touch Learning System User Manual

• Make sure the unit is turned OFF.
• Locate the battery covers on the back of the unit.
• Remove the covers as illustrated.
• Insert 4 X 1.5v size AA AM-3 or LR6 batteries
(not included) as illustrated.
• Make sure to replace the battery covers.
BATTERy NOTICE
• Install batteries correctly observing the polarity (+, -) signs to avoid leakage.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult supervision (if removable).
• Rechargeable batteries are to be removed from the toy before being charged
(if removable).
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc) or
rechargeable (Ni-MH).
• Remove the batteries from the equipment when the unit will not be used for
an extended period of time.
• Always remove exhausted batteries from the equipment.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
NoTe: When the MobiGo
you may see this icon appear on the screen
indicates that battery power is low, and you should replace
the batteries soon. Battery time remaining once the icon
first appears is approximately 10-30 minutes, depending on
the type of batteries in use.
To preserve battery life, MobiGo
off after several minutes without input. Press the ON/OFF
button to turn the MobiGo
135800 MobiGo2 M 20120510.indd 3

Battery Installation

Battery Installation
®
2 is running on batteries,
®
. This
2 will automatically turn
®
2 on again.
3
2012-5-30 10:17:11