Dell Force10 C150 Manual page 20

Installing and maintaining the c150 system

Hide thumbs Also See for Force10 C150:

Table of Contents

Step

Task

Rotate the levers toward the card to seat the backplane connectors and line card in place. Push on the knurled

section of the levers until the thumb tabs pop up and lock the unit in place, as shown in

CAUTION:

the card below it when that card is inserted.

Figure 5-3. Closing the Levers

Figure 5-4. Pressing the Knurled Section of the Lever

Install a blank panel in all slots that do not have a card, and secure it with the screws provided.

NOTE:

blank panels are installed in the correct slots.

RPMs and Line Cards

Installing a card without fully engaging the locking mechanism might damage the EMI seal on

The blank panels for RPMs and line cards are different sizes (RPM blanks are smaller); be sure that

Figure 5-3

and

Figure 5-4.

Table of Contents