Remote Control; General - Insignia NS-39D400NA14 User Manual

Problem Solution
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
correctly connected to your TV
not work.
and a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly
at the remote control sensor on
your TV. For the location of the
remote control sensor, see "Front"
on page 8.
• The supplied batteries are
wrapped tightly in clear plastic.
Make sure that you have removed
this plastic from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control
page 35.
• Replace dead batteries with new
batteries. See
control
Trouble
• See instructions and a table of
programming
common codes in
your existing
universal remote
universal
page 76.
remote
• Codes are subject to change. For
control.
up-to-date codes, go to
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries. See
control
• Refer to the User Guide that
accompanied your universal
remote control and contact the
manufacturer if problems persist.
71
"Adjusting sound settings" on
page 43.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
"Installing
batteries" on
"Installing remote
batteries" on page 35.
"Programming
controls" on
"Installing remote
batteries" on page 35.
www.insigniaproducts.com
NS-39D400NA14 Insignia 39" LED TV

General

Problem Solution
No power.
• Make sure that the power cord
is correctly connected to your
TV and a power outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord
back in and turn on your TV.
• Other devices (for example, a
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
"No signal"
• Press INPUT and make sure that
error message is
you have selected the correct
displayed.
input for the device or service
you are trying to use.
• If you are using a cable or
satellite box, use the remote
that came with that box to
change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
After Auto
• Reception can vary by channel
Channel Search,
depending on the broadcast
there are no
power level of a given station.
channels.
Contact your cable or satellite
TV provider.
• Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
• Try replacing the cable between
the antenna/cable or
cable/satellite box and your TV.