Indicator Leds - Dell PowerConnect W-Series FIPS Manual

2.4.1.3

Indicator LEDs

There is an array of LEDs which operate as follows:
Table 5- AP-175 Indicator LEDs
Label LED Function
Position
PWR D11 AP power / system status
ENET0 D15 Ethernet Network Link
Status / Activity
WLAN0 D6 Radio0 Status
WLAN1 D1 Radio1 Status
SS1 D7/D2 Signal
(Radio0/Radio1)
significant bit
SS2 D8/D3 Signal
(Radio0/Radio1) second
most significant bit
SS3 D9/D4 Signal
(Radio0/Radio1)
significant bit
SS4 D10/D5 Signal
(Radio0/Radio1)
significant bit
Action
Off
Red
Flashing - Green
On - Green
Off
On - Yellow
On - Green
Flashing
Off
On - Orange
Off
On - Blue
Strength On - Orange/Blue
least
(For Radio0: Orange and
For Radio1: Blue)
Strength
Off
Strength
least
Strength
most
15
Status
No power to AP
System Alarm
Power did not connect
well or equipment failure
Device ready
Ethernet link unavailable
10/100Mbs Ethernet link
negotiated
1000Mbs Ethernet link
negotiated
Ethernet link activity
Radio0 disabled
Radio0 enabled
Radio1 disabled
Radio1 enabled
SS1 to SS4 LEDs turn
on/off depending on the
signal strength of the
current radio neighbors.
Stronger the signal, more
LEDs get lit starting with
SS1 (least signal strength
indicator) all the way to
SS4 (highest signal
strength indicator).