Playback Of A Video Tape; Checking The Amount Of Tape Remaining; Playing Back A Video Tape Repeatedly - Sharp VC-MH722LM Operation Manual

ADVANCED OPERATION

PLAYBACK OF A VIDEO TAPE

CHECKING THE AMOUNT OF TAPE REMAINING

When you load a video tape into the VCR it can calculate approximately the amount of
video tape remaining in hours and minutes. This is useful in determining whether or not there is
sufficient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is calculated for you
automatically.
To display the amount of video tape remaining:
1.
Load the video tape into the VCR
2.
Press DISPLAY
the VCR display. The tape will wind forward and then return to its original position. The
tape remaining will be shown on the VCR display in hours and minutes.
By pressing the TAPE SPEED
change between long play and standard play.
For example,
in standard play 1 hour 23 minutes is left on the tape:
in long play 2 hour 46 minutes is left on the tape:
NOTES:
• If tape remaining function is interrupted, the remaining time will not be displayed.
• If less than 5 minutes of tape remains the display will flash.

PLAYING BACK A VIDEO TAPE REPEATEDLY

You can set your VCR to automatically rewind at the end of playing a video tape and replay
the entire tape again. REPEAT will appear on the on-screen display when selected.
To use this feature:
1.
Press MENU to display the main menu on the
screen.
2.
Press the[ /
select MODE.
3.
Press SET .
4.
Press [ / ]to select REPEAT.
5.
[ / ]
Press to select ON.
6.
SET
Press .
7.
Press MENU to return to normal screen.
If problems persist contact the SHARP Helpline on tel: 0990-274277
on the remote control as many times as necessary until "R" appears on
button on the remote control the remaining time will
]menu select buttons to
MODE MENU SCREEN
B L U E MU T E
➝R E P E A T
: S E L E C T
S E T : E N T E R
19
PR
PR
PR
PR
AU T O O F F
ON O F F
: CHANGE
ME NU : E X I T