Table of Contents
Advertisement
ADVANCED OPERATION
PLAYBACK OF A VIDEO TAPE
CHECKING THE AMOUNT OF TAPE REMAINING
When you load a video tape into the VCR it can calculate approximately the amount of
video tape remaining in hours and minutes. This is useful in determining whether or not there is
sufficient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is calculated for you
automatically.
To display the amount of video tape remaining:
1.
Load the video tape into the VCR
2.
Press
DISPLAY
the VCR display. The tape will wind forward and then return to its original position. The
tape remaining will be shown on the VCR display in hours and minutes.
By pressing the
TAPE SPEED
change between long play and standard play.
For example,
in standard play 1 hour 23 minutes is left on the tape:
in long play 2 hour 46 minutes is left on the tape:
NOTES:
•
If tape remaining function is interrupted, the remaining time will not be displayed.
•
If less than 5 minutes of tape remains the display will flash.
PLAYING BACK A VIDEO TAPE REPEATEDLY
You can set your VCR to automatically rewind at the end of playing a video tape and replay
the entire tape again. REPEAT will appear on the on-screen display when selected.
To use this feature:
1.
Press the
MENU
main menu on the screen.
2.
Press the[
/
select MODE.
SET
3.
Press the
SET
4.
Press [
/
]to select REPEAT.
5.
[
/
]
Press
to select ON.
SET
6.
Press the
SET
7.
Press the
MENU
normal screen.
If problems persist contact the SHARP Helpline on tel: 0990-274277
on the remote control as many times as necessary until "R" appears on
button on the remote control the remaining time will
button to display the
]menu select buttons to
button.
button.
button to return to
MODE MENU SCREEN
B L U E MU T E
➝R E P E A T
: S E L E C T
S E T
: E N T E R
16
Pr
Pr
Pr
Pr
AU T O
O F F
ON
O F F
: CHANGE
ME NU : E X I T
Advertisement
Table of Contents
