Table of Contents
Advertisement
ADVANCED OPERATION
PLAYBACK OF A VIDEO TAPE
CHECKING THE AMOUNT OF TAPE REMAINING
When you load a video tape into the VCR it can calculate approximately the amount of
video tape remaining in hours and minutes. This is useful in determining whether or not there is
sufficient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is calculated for you
automatically.
To display the amount of video tape remaining:
1.
Load the video tape into the VCR
2.
Press
the VCR display. The tape will wind forward and then return to its original position. The
tape remaining will be shown on the VCR display in hours and minutes.
For example:
In Standard Play, 1 hour 23 minutes is left on the tape:
In Long Play, 2 hours 46 minutes is left on the tape:
In Extended Play, 4 hours 9 minutes is left on the tape:
NOTES:
•
Do not interrupt the tape remaining calculation.
•
If less than 5 minutes of tape remains the display will flash.
PLAYING BACK A VIDEO TAPE REPEATEDLY
You can set your VCR to automatically rewind at the end of playing a video tape and replay
the entire tape again. REPEAT will appear on the on-screen display when selected.
To use this feature:
1.
Press
screen.
2.
Press [
3.
Press
4.
Press [
5.
Press [
6.
Press
7.
Press
Downloaded from:
http://www.usersmanualguide.com/
on the remote control as many times as necessary until "R" appears on
DISPLAY
MENU
to display the main menu on the
K
L
/
] to select MODE.
SET
.
K
L
/
] to select REPEAT.
H
J
/
] to select ON.
SET
.
MENU
to return to normal screen.
MODE MENU SCREEN
B L U E MU T E
➝R E P E A T
: S E L E C T
S E T
: E N T E R
GB-16
AU T
O
O F F
ON
O F F
: CHANGE
ME NU : E X I T
Advertisement
Table of Contents
