Setup; Resetting To Factory Defaults - Navman WIND 3100 Installation And Operation Manual

A single unit can be wired as shown below:
With several instruments, use the optional
junction boxes to simplify wiring, as shown
below:
Group 1
Power/data cables
Group 2
NavBus cable
Power/data cable
For information on how to connect NavBus and
to use junction boxes, refer to the NavBus
Installation and Operation manual.
2 Tape or cover any unused wires or connectors
to protect them from water and keep them from
shorting together.

8-2 Setup

1 Take the boat for a trial run to check that all the
instruments work correctly.
2 To displayVMG, true wind speed and direction,
the WIND 3100 must be connected to an
instrument that outputs boat speed. If the
WIND 3100 is connected to an instrument that
outputs speed through water and to an
instrument that outputs speed over ground,
then you can select which the WIND 3100 will
use (see sections 3-1 and 6):
WIND 3100 Installation and Operation Manual
Junction box
Power & data
connections
Junction box
Power & data
connections
Mode is
or
i Press +
Speed Mode screen is displayed:
ii Press or
(Speed over ground) or
through water).
iii Press .
3 If the unit is part of a system of 3100 series
instruments connected by NavBus, set the
backlight group number (see section 6-1):
i Press +
Backlight Group screen is displayed:
ii Press or
number.
iii Press .
4 Set:
The speed units (see section 4-1) .
The pointer type (see section 3-2).
5 Calibrate if required:
Wind alignment (see section 3-4).
Wind speed (see section 4-4).

8-3 Resetting to factory defaults

All settings may be reset to the manufacturer's
default settings (see below).
Wind speed units ................................ knots
Pointer type ................................................. 1
Direction damping ...................................... 2
Steering angle ......................................... 40°
Steer angle resolution .......... 2° per segment
Wind speed alarm .................................... Off
SIMULATE mode ...................................... Off
Backlight Level ........................................... 0
Backlight Group .......................................... 1
Boat Speed Input ......................................
To reset to factory defaults:
1 Turn the power off.
2 Hold down +
on and continue to hold the keys down for at
least five seconds.
several times until the
Group is 3
to change the mode to
(boat speed
several times until the
to set the backlight group
while you turn the power
15