Getting Started - Navman FISH 4200 Installation And Operation Manual

2 Getting started

Power and transducer connection
The FISH 4200 has two sockets located on the rear of
the unit. The power cable has a black 8 pin LT
connector plug. Push this plug into the lower socket,
which has a black nut and is located on the rear of the
display unit, then turn the collar to lock. Make sure
that the collar is secure for a watertight connection.
The transducer cable has a blue 8 pin LT connector
plug. Push this plug into the upper socket, which has
a blue nut and is located on the rear of the display
unit, then turn the collar to lock. Make sure that the
collar is secure for a watertight connection.
If the transducer is not connected, the message "NO
TRANSDUCER DETECTED. ENTER SIMULATION
MODE?" will appear. Press
or NO. (More information on the simulation mode can
be found in the following section). Press
confirm the selection and the startup sequence will
continue. (Note: If the transducer was not intentionally
disconnected, turn the display unit off and refer to the
section on Troubleshooting in Appendix B.)
Names of keys:
Cursor key
+
gain key
-
gain key
Power key
Definition of Press and Hold in this manual:
· Press means to push the key for less than one
second.
· Hold means to push and hold the key down for
more than one second.
Power on
To turn the fishfinder on press
Note: if the unit is wired for Auto Power (see section
5-4) the fishfinder will turn on automatically when
the boat's ignition is turned on.
6
to switch between YES
key
.
A title screen briefly appears which displays basic
product information, including the software version.
The FISH 4200 then automatically displays the
screen that was last used.
Power off
To turn the fishfinder off, hold
appears. Continue to hold
the fishfinder turns off.
Note: if the unit is wired for Auto Power (see
section 5-4) the fishfinder can only be turned off
when the boat's ignition is turned off.
Language selection
To check which language is currently selected,
press to display the MAIN MENU.
to
Follow these steps to change the language:
1. Power off the unit.
2. While the unit is off, hold down the
3. Keep holding down the
on the unit.
4. The screen displays a list of languages.
Press the Cursor
language, then press the Cursor
select it. The fishfinder will continue the
startup sequence.
For further information, see section 4-8.
Backlighting
Use the button to adjust the backlighting to suit
individual preferences.
Press once, at any time, to see the backlight
bar. This is displayed at the bottom of the screen
and shows the current setting.
Press repeatedly until the desired backlighting
level is achieved. The backlight bar will disappear
2 seconds after the last press.
Fuel Computer
With an optional fuel kit the FISH 4200 becomes a
sophisticated yet easy to use fuel computer.
. A countdown box
for three seconds until
key and power
or key to highlight a
FISH 4200 Installation and Operation Manual
key.
key to