Table of Contents
Advertisement
25175H—March 2003
7
Advanced 333 Front-Side Bus AMD Athlon™ XP
Processor Model 8 Specifications
7.1
Electrical and Thermal Specifications for the Advanced 333 FSB
AMD Athlon™ XP Processor Model 8
Table 5.
Electrical and Thermal Specifications
V
CC_CORE
Frequency in MHz
(Core
(Model Number)
Voltage)
2083 (2600+)
1.65 V
2167 (2700+)
Notes:
1. See Figure 3, "AMD Athlon™ XP Processor Model 8 Power Management States" on page 9.
2. The maximum Stop Grant currents are absolute worst case currents for parts that may yield from the worst case corner of the
process and are not representative of the typical Stop Grant current that is currently about one-third of the maximum specified
current.
3. These currents occur when the AMD Athlon™ system bus is disconnected and has a low power ratio of 1/8 for Stop Grant
disconnect and a low power ratio of 1/8 Halt disconnect applied to the core clock grid of the processor as dictated by a value of
2003_1223h programmed into the Clock Control (CLK_Ctl) MSR. For more information, refer to the AMD Athlon™ and
AMD Duron™ Processors BIOS, Software, and Debug Developers Guide, order# 21656.
4. The Stop Grant current consumption is characterized at 50°C and not tested.
5. Thermal design power represents the maximum sustained power dissipated while executing publicly-available software or
instruction sequences under normal system operation at nominal V
the processor to prevent the processor from exceeding its maximum die temperature.
Chapter 7
Advanced 333 Front-Side Bus AMD Athlon™ XP Processor Model 8 Specifications
Preliminary Information
This chapter describes the electrical specifications that are
unique to the advanced 333 front-side bus (FSB) AMD Athlon™
XP processor model 8.
Table 5 shows the electrical and thermal specifications for this
processor in the C0 working state and the S1 Stop Grant state.
I
(Processor Current)
CC
Working State C0
Maximum Typical Maximum Typical Maximum Typical
41.4 A
37.6 A
AMD Athlon™ XP Processor Model 8 Data Sheet
Thermal Power
1, 2, 3, 4
Stop Grant S1
8.9 A
5.9 A
68.3 W
. Thermal solutions must monitor the temperature of
CC_CORE
5
Maximum Die
Temperature
62.0 W
85°C
27
Advertisement
Table of Contents
