Before Calling For Service; Error Messages And Countermeasures; Instructions For Transportation - Kodak 305 User Manual

ERROR MESSAGES AND COUNTERMEASURES


For the following symptoms, check the printer again before calling for service.
Symptom
The power is not turned on.
The printing unit doesn't open.
The image is not printed.
An error can not be resolved.
When transporting this printer for some reason such as repair, follow the instructions below.
1. Use the original packaging.
The genuine package unit may not endure more than one round trip. If the printer is transported with the package unit more
than one round trip, it may not be guaranteed.
Purchase another package unit when transporting this printer again.
Pack the printer with the accessories (ribbon and print paper) removed.
2. Close the printing unit firmly.
When closing the printing unit, push it until a click is heard.
When the printing unit is not closed firmly or you press the OPEN button accidentally, the printing unit may open. It can
cause injury or damage.
3. If the ribbon, print paper, or ribbon cassette can not be taken out, consult with your dealer.

BEFORE CALLING FOR SERVICE

Is the power cord plug disconnected from the outlet?
→ Connect the power cord plug to the outlet firmly.
→ The protective circuit may be working. Turn off the power and wait for
about two minutes. Then turn on the power again.
Are you turning off the power during printing procedure?
→ Turn on the power and then open the printing unit.
Is the PAPER RIBBON indicator or the ALARM indicator illuminating or
blinking?
→ Refer to "Overcoming paper jams."
Is the appropriate size of data sent to this printer?
→ Make sure that the appropriate size of image data is sent to this printer.
Is the print paper or the ribbon used up?
→ Check them.
Is the printing unit set firmly?
→ Set the printing unit firmly.
→ When the indicators keep illuminating or blinking though the above
operations are performed, remove the ribbon and print paper and
reinstall them.
→ Turn off and on the power of the printer with the printing unit set firmly.
This printer starts initialization.
→ Press the switch inside of the hole of the front panel with a thin stick or
the like for 5 seconds or more.
Switch

INSTRUCTIONS FOR TRANSPORTATION

Check & Remedy
CAUTION
19