Pioneer KEH-P4010R Operation Manual page 5

MAN-KEH-P5010R-GB_B.fm Page 5 Friday, October 6, 2000 2:22 PM
This product conforms to new cord colors.
Antenna jack
Depending on the kind of vehicle, the function
of 3* and 5* may be different. In this case, be
sure to connect 2* to 5* and 4* to 3*.
Multi-CD player
(sold separately)
Cap (1*)
When not using this terminal,
do not remove the cap.
Yellow (3*) Yellow (2*)
Back-up To terminal always supplied
(or accessory) with power regardless of
ignition switch position.
Red (5*) Red (4*)
Accessory To electric terminal controlled
(or back-up) by ignition switch (12 V DC)
ON/OFF.
Black (ground)
To vehicle (metal) body.
ISO connector
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to connect
to both connectors.
This product
Rear output
A
IP-BUS input (Blue)
Fuse
IP-BUS cable
B
Connect leads of the
same color to each other.
C
D
Speaker leads
: Front left +
White
: Front left -
White/black
: Front right +
Gray
: Front right -
Gray/black
: Rear left +
Green
: Rear left -
Green/black
: Rear right +
Violet
: Rear right -
Violet/black
A
Connecting cords with RCA pin plugs
(sold separately)
Yellow/black
If you use a cellular telephone, connect it via the Audio
Mute lead on the cellular telephone. If not, keep the Audio
Mute lead free of any connections.
B
Blue/white
To system control terminal of the
power amp (Max. 300 mA 12 V DC).
C
Rear speaker (Left)
D
Blue/white (7*)
Blue/white (6*)
To Auto-antenna relay control terminal (max. 300 mA 12 V DC).
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another type
of vehicle, never connect 6* and 7*.
Power amp
(sold separateley)
System remote control
Rear speaker (Right)
Perform these connections when using a
different amp (sold separately).