Installing The Speakers On The Tallboy Stand - Samsung HT-D450 User Manual

Installing the Speakers on the Tallboy Stand

* HT-D453 only - Front Speakers
* HT-D455 only - Front/Surround Speakers
1. Turn the Stand Base upside-down and connect it to
the Stand.
2. Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
3. Connect the upper Speaker to the assembled Stand.
4. Insert another large screw (5*15, For connecting Speaker
& Stand) clockwise into the hole on the rear of the
speaker using a screwdriver.
5.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
Connecting The Speakers
1. Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
3.
Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
In case of HT-D450
Front Speaker (R)
Surround Speaker (R)
* Refer to page 16 for the speakers of HT-D453/D455.
1
Stand
Base
Stand
3
Speaker
Stand
5
Black
Center Speaker
Front Speaker (L)
Surround Speaker (L)
Subwoofer
2
4
Red
17
English