Installing The Speakers On The Tallboy Stand - Samsung HT-F6550W User Manual

Installing the Speakers on the Tallboy Stand

1. Turn the Stand Base upside-down and connect it to the Stand.
2. Use the driver to combine the screws on the 4 marked holes.
3. Straighten a supplied speaker wire to the gravity direction and put
in the hole on the center of Stand Base.
4. Connect the upper Speaker to the assembled Stand.
5. Insert a screw clockwise into the hole on the rear of the speaker
using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
Connecting The Speakers
1. Match each speaker cable bundle to the correct speaker by matching the color coded
plug on each bundle to the colored sticker on the bottom of each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire, and then
release the tab.
b. Press down the black tab on the back of the speaker, insert the black wire, and then
release the tab.
3. Connect the speaker wire plugs from each speaker to the back of the product by
matching the colors of the speaker plugs to the colors of the speaker jacks.
4. Connect the left and right surround speakers to the wireless receiver module.
Again, match the color of the plugs to the jacks on the wireless receiver module.
5. Plug the power cord of the wireless receiver module into a wall outlet.
6. Turn on the product. The product and wireless receiver module will now communicate with each other and you will
hear sound from the Surround speakers.
Wireless Receiver Module
Surround Speaker (L)
* This product should be connected with the SWA-6000 only.
Front Speaker (R)
Subwoofer
Surround Speaker (R)
Stand Base
1 2
Stand
3 4
Speaker
5 6
Black
Front Speaker (L)
SPEAKERS OUT
FRONT FRONT
R L
SUBWOOFER CENTER
Center Speaker
SPEAKERS OUT
FRONT FRONT L
R
SUBWOOFER CENTER
HDMI OUT
Stand
Red
15
|
English