Replacing A Basket Lift Motor Or Microswitch - Frymaster PASTAMAGIC 8196692 Service And Parts Manual

Disconnect water line at
this compression fitting.
5. Separate the faucet from the water inlet manifold and mounting plate as shown in the illustration
above.
6. Reverse Steps 1-5 to complete the procedure.

1.3.6 Replacing a Basket Lift Motor or Microswitch

1. Disconnect the cooker from the electrical power supply.
2. If rigid water connections have been used, disconnect the cooker from the incoming water
supply.
3. Remove the basket lift arms from the lifter rods and then reposition the cooker to gain access to
the rear. Remove the upper and lower basket lift rear panels.
4. Disconnect the basket lift synchronizer link from the lifter cam (bell crank) assemblies one at a
time. When the link is disconnected from a cam, slip the corresponding lifter rod down and out
of the assembly (see illustration on below).
Lifter Rods
Remove the six screws in
the faucet mounting plate.
Lifter Cams
Loosen this nut to separate the
faucet from the water inlet manifold.
Note the collection of washers and
spacers between the link and lifter rods.
Synchronizer Link
Disconnect the basket lift synchronizer
link from the lifter cams and slip the lifter
rods down and out of the assembly.
1-7
Remove this nut to separate the
faucet from the mounting plate.