Replacing The Cookpot Or Rinse Tank - Frymaster PASTAMAGIC 8196692 Service And Parts Manual

Burners
3. Reconnect the cooker to the gas supply and check all connections for leaks using a solution of
soapy water.
DO NOT use matches, candles, or other ignition methods to check for leaks.
4. When satisfied that there are no leaks, reconnect the unit to the electrical supply, and reconnect
any restraints disconnected in Step 1.

1.3.8 Replacing the Cookpot or Rinse Tank

NOTE: The following procedure addresses removing the cookpot or rinse tank from a GPC unit.
The procedure is essentially the same for a GPC, GPCB, GPCR and GPCRB units, except that there
is no faucet on the GC, GPC or GPCB units. There are no basket lifts on the GC and GPC units.
1. Remove the basket lift arms from the lifter
rods.
2. Remove the faucet assembly from the cook-
er in accordance with Steps 1-4 of Section
1.3.5.
3. Remove the screws that secure each of the
rear corners of the backsplash assembly (see
illustration at right). NOTE: To access the
screw in the lower right corner (as viewed
from the rear) the upper basket lift back
panel must be removed.
4. Remove the screws along the top edge of the
control panel and open the panel by
DANGER
swinging it downward. Disconnect the 15-
pin connector from the rear of the controller
and the wires attached to the trouble light,
and then lift the control panel out of the
control panel frame.
5. Remove the screws that secure the back-
splash sides to the cabinet sides then remove
the four screws that secure the topcap to the
cabinet.
6. Remove the top connecting strip.
7. Remove the screws attaching the standoff
brackets to the cookpot or rinse tank.
1-9
Blower and plenum
removed