System Settings - Xerox DocuPrint C1110 User Manual

System Settings

[System Settings] menu is used to make the printer operation settings such as for alarm and
power saver mode.
Item
Low Power Timer
Sleep Mode
Sleep Mode Timer
Audio Tones
92
5 Control Panel Menus
Sets the amount of time before the printer enters the Low Power mode. Specify the
value in 1 minute increments.
• [3 Minutes] to [60 Minutes] (default: [3 Minutes])
Refer to
• "Setting/Exiting the Power Saver Modes" (P. 39)
• "Setting Example: Changing the Power Saver Mode Setting" (P. 86)
Consumes less electricity than the Low Power mode. Set whether or not to enable this
feature.
• [Enable] (default)
• [Disable]
Note
• [Sleep Mode] does not appear on the model available in China. The Sleep mode
cannot be disabled on the Chinese model.
Refer to
• "Setting/Exiting the Power Saver Modes" (P. 39)
Sets the amount of time before the printer enters the Sleep mode from the Low Power
mode. Specify the value in 1 minute increments.
• [2 Minutes] to [120 Minutes] (default: [2 Minutes])
Note
• When [Sleep Mode] is set to [Disable] (default: [Enable]), the printer does not shift to
the Sleep Mode.
Refer to
• "Setting/Exiting the Power Saver Modes" (P. 39)
Sets the audio tones that indicate various printer conditions such as errors. You cannot
adjust the sound volume.
• [Control Panel] (default: [On])
Sets whether or not to generate an audio tone when the correct button is pressed on
the control panel.
• [Invalid Key] (default: [On])
Sets whether or not to generate an audio tone when the wrong button is pressed on
the control panel, or when an operation is attempted during an error.
• [Machine Ready] (default: [On])
Sets whether or not to generate an audio tone to inform you that the printer is ready
to print (such as right after powering on).
• [Job Completed] (default: [On])
Sets whether or not to generate an audio tone when a job finishes successfully.
• [Fault Tone] (default: [On])
Sets whether or not to generate an audio tone when a job finishes abnormally.
• [Alert Tone] (default: [On])
Sets whether or not to generate an audio tone when a fault (such as a paper jam)
occurs and a job is held in a fault state.
• [Out of Paper] (default: [On])
Sets whether or not to generate an audio tone when the printer runs out of paper and
a job is held in a fault state.
• [Low Toner Alert] (default: [On])
Sets whether or not to generate an audio tone when the toner cartridge needs to be
replaced.
• [Base Tone] (default: [On])
Sets whether or not to generate an audio tone when a button, which toggles between
different options when pressed repeatedly, is pressed.
Description