Xerox DocuPrint C1110 User Manual page 119

Message
Ready to Print
Toner Cart [X]
Ready to Print
Reorder Spare
(X: Y, M, C, or K)
Reboot printer
(***-***)
Reload Manual
Feeder
Replace Drum
Cartridge
Remove paper
from Manual Feed
Remove & Shake
Toner Cart [X]
(X: Y, M, C, or K)
Remove Drum
Cartridge Tapes
Replace Toner
Cartridge [X]
(X: Y, M, C, or K)
Set Fuser Unit
in Place
Then Reboot
Printer
SET to print
CANCEL to Abort
The toner in the X toner cartridge is low. Have a new cartridge ready.
The printer may be at fault.
Switch the power off, wait for the display to go out, and switch the power back on
again. If the same error code is displayed, copy down the error code (***-***), and
contact our Customer Support Center or your dealers.
Refer to
• "Network-related Problems (DocuPrint C1110 only)" (P. 121)
The paper is not loaded correctly in the manual feeder. Remove the paper and load it
again.
After loading the paper, the [Press SET to continue] message appears. Press the
<Eject/Set> button on the control panel to start printing.
If the <Eject/Set> button is not pressed for 5 seconds, the printer will start printing
automatically.
Refer to
• " Loading Paper in the Manual Feeder" (P. 77)
It is time to replace the drum cartridge.
Replace the drum cartridge.
Refer to
• " Replacing the Drum Cartridge" (P. 130)
• "Types of Consumables" (P. 125)
The paper is loaded into the manual feeder, but the job requested the tray 1.
Remove the paper from the manual feeder.
This message appears when the output color for the X toner cartridge is light.
Remove the X toner cartridge from the printer and shake the toner cartridge. This
may solve the problem.
The yellow tapes are not removed from the drum cartridge.
Remove the drum cartridge from the printer, completely pull out the yellow tapes
from the side of the cartridge, and then reinstall it to the printer.
The X toner cartridge has run out of toner, or the waste toner box becomes full.
Replace the X toner cartridge.
Refer to
• "Replacing the Toner Cartridges" (P. 128)
• "Types of Consumables" (P. 125)
The fuser unit is not installed correctly.
Switch the power off, and then reinstall the fuser unit.
To print the job, press the <Eject/Set> button, or to cancel the job, press the <Cancel
Job> button on the control panel.
Symptom/Cause/Remedy
6.6 Error Messages (in Alphabetical Order)
119