Hardware Problems; (Power Failure, Abnormal Noise, Etc.) - Xerox DocuPrint C1110 User Manual

6.2

Hardware Problems

(Power Failure, Abnormal Noise, etc.)

Symptom
The printer will not switch on.
The display is blank.
The printer makes odd noise.
Dew condensation formed in
the printer.
The printer does not switch to
the Sleep mode.
106
6 Troubleshooting
Is the power switched on?
Switch the power on by pressing the power switch to the <|> position.
Is the power cord firmly plugged into the power outlet?
Switch the power off, plug the power cord firmly into the power connector or power
outlet, and switch the power back on.
Is the printer plugged into a power outlet that supplies proper voltage?
Connect the printer to a power outlet that supplies the proper rated voltage or current.
And do not share the power outlet with other devices.
The printer may be in the Power Saver mode. Press the <Power Saver> button on the
control panel to exit the Power Saver mode.
If this does not remedy the problem, check if the power cord is firmly plugged into the
power outlet, and reboot the printer.
If the problem still persists, the printer may be at fault. Contact our Customer Support
Center or your dealers.
Is the printer installed on a level surface?
Move the printer on a level and sturdy surface.
Are the paper trays pushed in completely?
Push the trays firmly into the printer.
A foreign object may be in the printer.
Switch the power off and remove the object. If the object cannot be removed without
dismantling the printer, contact our Customer Support Center or your dealers.
On the control panel, set the interval that the printer switches to the Sleep mode to
more than 60 minutes, and let the printer stand with its power on. After about an hour,
the condensation disappears due to the heat inside the printer.
Refer to
• Sleep mode: [System Settings] (P. 92)
Isn't the Sleet mode disabled?
On the control panel, set [Sleep Mode] to [Enable].
The [Sleep Mode] setting is not supported on the model available in China.
Cause/Remedy