Haier HWM70-1203D User Manual page 9

e ¬
spin speed
f ¬intense button
g ¬
extra rinse
h ¬
start/pause button
i ¬
eco
J ¬
leD Display
K ¬
Delay
¬To cancel a program
press the "start/pause" button, then switch off the power and the program is automatically cancelled. Turn the Turn on the power and use
the program selector again to choose another program.
¬
To cancel audible alarm
alarm sound can be cancelled if it is required (not recommended)
switch on the washing machine and turn the program knob to spin cycle, then press the "Delay" and "extra rinse" button, hold on for 3
seconds.
The message "beep off" will be displayed on the screen, indicating that the alarm sound has been cancelled.
¬
To reinstate audible alarm
switch on the washing machine and turn the program knob to spin cycle, then press the "Delay" and "extra rinse" button, hold on for 3
seconds.
The "beep on" message will be displayed on the screen, indicating that the alarm sound has been reinstated.
Before use
_ Touch this button lightly to select the desired speed. When a speed is set, it will be displayed on
the indicator.note: if there is no indicator light displayed, it means no spinning.
Note: Different water temperatures and spinning speeds can be set for different
laundries. wash using the default settings if there is no special requirement.
_if the laundry is heavily soiled, press this button before starting the program. When the button is
pressed, the washing time increases.
_ press this button, the washing machine will perform additional rinses. press the button once to
select one additional rinse. The display will show"p-1". press the button repeatedly and the screen
will display "p-2''or "p-3'', indicating two or three additional selected rinses. The "extra rinse light"
is activated and flashes during the performance. "p-1/2/3" is displayed alternating with the
remaining time. The light turns off and the display disappears when the extra rinse ends.
Note: Select this function when programe 1-9 is selected.
_ When the washing machine is connected to the power socket and a program is selected, lightly
touch this button to start operation. During a wash cycle, touch it lightly ,operation will stop and
the digits on the screen start blinking. Touch it again to resume operation. To cancel a wash program
during a wash cycle, touch this button, when the digits on the screen start blinking, press the power
switch, the program will be cancelled.
_before a washing program,select this program to set the washing load(1/2full),the washing
machine will automatically adjust the water consumption and washing time.
_information as remaining wash time and error messages will be shown here.
Note: After a wash program is started the display will go on and the remaining
wash time decreases. As the water pressure and temperature may differ, the
remaining time may be adjusted accordingly. when the laundry is not balanced
during spinning, the time may be automatically prolonged.
_Touch this button lightly, the washing machine will start operation after a period of time
and the corresponding indicator will go on. The range is 0.5-24 hours; each touch of this
button increases a half hour. after the button is set, press the start/pause button to start
countdown of the set time (the time is displayed on the screen until the program ends).
Note: The delay time must be longer than the program time otherwise the
washing machine will start the wash program directly.
09