Tape Duplication - Philips VR220/75 User Manual

Tape Duplication

1 Connect the recording VCR (this VCR) and the playing VCR.
2 Connect the recording VCR (this VCR) to the TV.
Playing VCR
ANT.IN
IN OUT
AUDIO
RF OUT
VIDEO
Dubbing from any VCR (or video camera) to
another is simple. Explanations on this page uses
this VCR as the recording VCR.
Refer also to the manual supplied with the other
VCR (for playback).
• You can also use the front AUDIO/VIDEO
input jacks.
• The remote control operation mode is set
correctly for operating your target component.
– Press VCR to operate the VCR.
1
On VCRs
Insert a source tape in the playing VCR and a
blank tape in the recording VCR.
• If a tape without the record tab is inserted in the play-
ing VCR, playback automatically starts. In this case,
press the STOP button.
2
On TV
Turn the channel on the TV to your video
channel.
3
Select Line Input
5 ∞
Press CHANNEL
or
control at this VCR, to select the external line
input.
220/75
Recording VCR (this VCR)
From audio out to AUDIO IN
From video out to VIDEO IN
, pointing the remote
— 21—
21
ANT.IN
IN OUT
AUDIO
RF OUT
VIDEO
To RF OUT
• For rear jacks, select "L-1" on the display or "A/V
IN" on the TV screen.
• For front jacks, select "L-F" on the display or
"F-A/V IN" on the TV screen.
4
Select Tape Speed
Press ALT/SPEED, pointing the remote control
at this VCR, until the desired tape speed (SP, LP
or SLP) appears on the display.
SP, LP: For PAL signal.
SP, SLP: For NTSC signal.
5
Play Back Tape
3
Press the PLAY
button on the playing VCR.
6
Record (Copy) Tape
Press REC/OTR q at this VCR.
Remember: Press the buttons in steps 5 and 6
simultaneously to avoid missing any of the
recording.
01.5.11, 4:17 PM
TV