Philips VR220CAT Install Manual

Hookup pages
Hide thumbs Also See for VR220CAT:

Advertisement

Quick Links

VR220CAT
Video Cassette Recorder
Hookup Pages

Advertisement

Table of Contents
loading

Summary of Contents for Philips VR220CAT

  • Page 1 VR220CAT Video Cassette Recorder Hookup Pages...
  • Page 2: Hookups Without A Cable Box/Direct Broadcast System

    Cable Box or a Direct Broadcast System, please see pages eight-nine. If you have a Stereo TV, please see page 10. After you hook up the VCR, go to page 11 to turn on the VCR. Disconnect the antenna or cable from your TV.
  • Page 3 Set the TV to the same channel. For example, when playing a tape, if the CH3/CH4 switch is set to CH3, the TV should be on channel 03. You are ready to turn on the VCR. Please go to page 11 before turning on the VCR. AUDIO...
  • Page 4: Hookups With A Cable Box/Direct Broadcast System

    You may not program channels at the VCR. You can only program a timer recording for one channel at a time. Set the TV and the VCR to the Cable Box/DBS output channel (channel 03 or 04); set the CH3/CH4 switch on the back of the VCR to the same channel.
  • Page 5: Recording One Channel/Watching Another

    VCR’s CH3/CH4 switch. Set the TV to the Cable Box/DBS output channel (03 or 04). Then, with the VCR in VCR position (the VCR/TV light will appear on the display panel), use the CH(annel) o/p buttons to select the channel you want to record at the VCR.
  • Page 6: Hookups With A Stereo Tv

    VCR. Connect a video cable to the yellow VIDEO OUT Jack on the back of the VCR. Then, connect the other end of the video cable to the VIDEO IN Jack on your TV. Connect an audio cable to the white AUDIO OUT Jack on the back of the VCR.
  • Page 7: Front Panel

    When playback is stopped, press to fast forward the tape at high speed. During tape playback, press to fast forward the tape while the picture stays on the screen. Details are on page 35. Press to select an item in the VCR menu. Remote Sensor...
  • Page 8: Rear Panel

    VIDEO OUT Jack Connect a video cable going to the VIDEO IN Jack of a camcorder, another VCR, or an audio-visual sys- tem (laser disc player, video disc play- er, etc.) here. Details are on page 32. VIDEO IN Jack...
  • Page 9: Helpful Hints

    VCR 1 will play your tape. Put a prerecorded tape in VCR 1. VCR 2 will record your tape. Insert a blank tape in VCR 2. The VCR must be in VCR position. (The VCR/TV light will appear on the display panel.

This manual is also suitable for:

Vr220cat99

Table of Contents