Table of Contents
Advertisement
11. Move the cut-sheet feeder's paper selection lever to the single-sheet
position, as shown below. Then lift up the center support and close the
paper guide cover.
Note:
Always close the printer cover before printing. The printer does not print when
the cover is open.
When the cut-sheet feeder is installed, you can still load single sheets one at a
time using the front paper slot.
The cut-sheet feeder automatically loads paper when the printer receives
data. Printed pages are stacked on the center support. If you need to eject a
sheet, press the Load/Eject button.
If the first printed line on your page appears too high or low, you can adjust
its position using the micro adjust feature. See "Adjusting the Top-of-Form
Position" on page 2-39.
Caution:
c
Never use the knob to adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
Enhancing Your Printer With Options
A
A-9
Advertisement
Table of Contents
