Installation - Electrolux EMS2685 Instruction Book

INSTALLATION

INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for
any signs of damage.
2. If fitting the microwave oven above a
conventional oven (position A) then use the mylar
sheet provided.
a. Cut the Mylar sheet to fit the internal width of
the unit.
b. Peel back the protective cover on the tape
and fix to the rear of
the shelf so
that it covers
the service
gap. (See
diagram).
Mylar sheet
The microwave can be fitted in position A or B:
Position A
Conventional
oven
POSITION NICHE SIZE
W D
A 560x550x450
B 560x500x450
Measurements in (mm)
Conventional
oven
Chimney
Position B
CHIMNEY
H (min) Cupboard & Ceiling
50
40
3. Fit the appliance into the kitchen cupboard
slowly, and without force, until the front frame of
the oven seals against the front opening of the
cupboard.
4. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the
cupboard door above
and the top of the frame
(see diagram).
5. Fix the oven in position with the
screws provided.
The fixing points are located
on the top and bottom corners
of the oven (see diagram, item
10, on page 5).
6. It is important to ensure that the installation of
this product conforms to the instructions in this
operation manual and the conventional oven
manufacturer's installation instructions.
Chimney
Gap Between
50
50
50
5 mm