Preparation Of The Oven; Installation Hardware - Electrolux EI30BM55HWB Installation Instructions Manual

Installation Instructions
5 TOOLS RECOMMENDED FOR
INSTALLATION
Phillips Screwdriver
Electric Drill
to", 2/3" and 3/32" Drill Bits
1 1/2" Wood Bit or Metal Hole Cutter
(if metal cabinet is used)
Saw to cut exhaust opening (if needed)
Protective Drop Cloth for product and range -
you may also use carton for protection
Scissors
Pencil
Measure
Tape
6 INSTALLATION HARDWARE
The INSTALLATION HARDWARE items @ - © are ina small
bag. All items are in a bag packed below the oven.
ltem Name Quantity
@D Wood Screw 5 x 35 mm 6
@) Toggle Bolt */16" 4
® Top Cabinet Screw 5 x 85 mm 2
® Flat Washer 30 mm diameter 2
© Grommet 1
© Tapping Screw 4 x 8 mm 3
@D Exhaust Damper Assembly 1
® Grease Filter 2
® Rear Cushion 1
Use with metal cabinets. Surround
the power cord opening. Cut to fit.
Figure 4
Parts shown not to common scale.
7 PREPARATION OF THE OVEN
1 .
Open the bottom of the carton, bend the carton flaps
back and tilt the oven over to rest on plastic foam pad.
Lift carton off oven and remove all packing materials,
Installation Instructions, Wall Template, Top Template,
Turntable and Turntable Support; however, DO NOT
REMOVE THE WAVEGUIDE COVER, which is located
on the ceiling in the oven cavity. SAVE THE CARTONAS
IT MAY MAKE INSTALLATION EASIER.
CHECK THE OVEN.
Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealing surfaces,
broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not
operate the oven and contact your dealer or Electrolux
AUTHORIZED SERVICER.
Mounting Plate
Figure 5